Igmp And Igmp Snooping Commands; Introduction - Allied Telesis x310-26FT Command Reference Manual

27

Introduction

Overview Devices running AlliedWare Plus use IGMP (Internet Group Management Protocol)
and MLD (Multicast Listener Discovery) to track which multicast groups their clients
belong to. This enables them to send the correct multimedia streams to the correct
destinations. IGMP is used for IPv4 multicasting, and MLD is used for IPv6
multicasting.
This chapter describes the commands to configure IGMP Querier behaviour and
selection, IGMP Snooping and IGMP Proxy.
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
C613-50103-01 REV A
IGMP and IGMP
"clear ip igmp" on page 1083
"clear ip igmp group" on page 1084
"clear ip igmp interface" on page 1085
"debug igmp" on page 1086
"ip igmp" on page 1087
"ip igmp access-group" on page 1088
"ip igmp flood specific-query" on page 1089
"ip igmp immediate-leave" on page 1090
"ip igmp last-member-query-count" on page 1091
"ip igmp last-member-query-interval" on page 1092
"ip igmp limit" on page 1093
"ip igmp maximum-groups" on page 1094
"ip igmp mroute-proxy" on page 1096
"ip igmp proxy-service" on page 1097
"ip igmp querier-timeout" on page 1098
"ip igmp query-holdtime" on page 1099
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Snooping
Commands
1081