Igmp And Igmp Snooping Commands; Introduction - Allied Telesis x510-28GTX Command Reference Manual

30

Introduction

Overview Devices running AlliedWare Plus use IGMP (Internet Group Management Protocol)
and MLD (Multicast Listener Discovery) to track which multicast groups their clients
belong to. This enables them to send the correct multimedia streams to the correct
destinations. IGMP is used for IPv4 multicasting, and MLD is used for IPv6
multicasting.
This chapter describes the commands to configure IGMP Querier behaviour and
selection, IGMP Snooping and IGMP Proxy.
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
C613-50170-01 Rev B
IGMP and IGMP
"clear ip igmp" on page 1192
"clear ip igmp group" on page 1193
"clear ip igmp interface" on page 1194
"debug igmp" on page 1195
"ip igmp" on page 1196
"ip igmp access-group" on page 1197
"ip igmp flood specific-query" on page 1198
"ip igmp immediate-leave" on page 1199
"ip igmp last-member-query-count" on page 1200
"ip igmp last-member-query-interval" on page 1201
"ip igmp limit" on page 1202
"ip igmp maximum-groups" on page 1203
"ip igmp mroute-proxy" on page 1205
"ip igmp proxy-service" on page 1206
"ip igmp querier-timeout" on page 1207
"ip igmp query-holdtime" on page 1208
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Snooping
Commands
1190