Show Cmm - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show cmm

Displays basic hardware and status information for the CMM modules in a standalone switch or the
switches that perform the CMM role running in a stack.
show cmm [number]
Syntax Definitions
number
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
If a switch, which performs a secondary CMM role in a stack, the hardware and status information for
both the switches that perform the primary and secondary CMM role will be displayed.
•
This command may be used when logged into the switch that performs either the primary or secondary
CMM role in a stack.
Examples
-> show cmm
CMM in slot 1
Model Name:
Description:
Part Number:
Hardware Revision:
Serial Number:
Manufacture Date:
Firmware Version:
Admin Status:
Operational Status:
Power Consumption:
Power Control Checksum:
MAC Address:
output definitions
Model Name
Description
Part Number
Hardware Revision
Serial Number
page 2-36
Specifies the CMM slot number within a standalone switch or the CMM
switch number within a stack switches.
OS6250-24,
10/100/1000,
902271-10,
002,
E23L9059,
JUN 08 2004,
N/A,
POWER ON,
UP,
0,
0x0,
00:d0:95:a3:e5:09,
The model name of the switch.
A factory-defined description of the associated board (e.g., BBUS
Bridge or PROCESSOR).
The Alcatel-Lucent part number for the board.
The hardware revision level for the board.
The Alcatel-Lucent serial number for the board.
OmniSwitch 6250 CLI Reference Guide
Chassis Management and Monitoring Commands
November 2009