HP ProCurve 7102dl Reference Manual page 508

SROS Command Line Interface Reference Guide
snmp-server group
Use the snmp-server group command to specify a new Simple Network Management Protocol (SNMP)
group to control access to SNMP information. Use the no form of this command to remove a specified
group. Variations of this command include:
snmp-server group <groupname> v1 read <name> write <name> notify <name> access <listname>
snmp-server group <groupname> v2c read <name> write <name> notify <name> access <listname>
snmp-server group <groupname> v3 auth read <name> write <name> notify <name>
access <listname>
snmp-server group <groupname> v3 noauth read <name> write <name> notify <name>
access <listname>
snmp-server group <groupname> v3 priv read <name> write <name> notify <name>
access <listname>
Syntax Description
access <listname>
<groupname>
notify <name>
read <name>
write <name>
v1
v2c
v3
Default Values
If no views are specified, the system automatically assigns default read- and notify-views that have no
restrictions.
Usage Examples
The following example defines a group called securityV3auth using version 3 security model,
authentication, and no access control list to verify:
ProCurve(config)#snmp-server group securityV3auth v3 auth
5991-2114
Specifies an access control list entry.
Specifies the name of the SNMP group (32 characters maximum).
Specifies a notify-view entry (32 characters maximum).
Specifies a read-view entry (32 characters maximum).
Specifies a write-view entry (32 characters maximum).
Uses SNMP version 1 security model.
Uses SNMP version 2c security model.
Uses SNMP version 3 user-based security model (USM)
Options if v3 is used:
auth Indicates that authentication is used.
noauth Indicates that no authentication is used.
priv Indicates that privacy authentication is used.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
506