SROS Command Line Interface Reference Guide
bridge-group <group#> vlan-transparent
Use the bridge-group vlan-transparent command to prevent an interface from removing the VLAN tag.
Use the no form of this command to allow the interface to remove the VLAN tag from the packet.
Note
The bridge-group vlan-transparent command is not a global command. The command must
be applied on all interfaces of the bridge group.
Syntax Description
<group#>
Default Values
By default, VLAN tags are removed from the data.
Usage Examples
The following example removes the VLAN tags from the packets on the Ethernet interface 0/1:
ProCurve(config)#interface ethernet 0/1
ProCurve(config-eth 0/1)#bridge-group 1 vlan-transparent
5991-2114
Specifies the bridge group number. Valid range is 1 to 255.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Ethernet Interface Configuration Command Set
623