HP ProCurve 7102dl Reference Manual page 581

SROS Command Line Interface Reference Guide
bonding txfa-timer <seconds>
Use the bonding txfa-timer command to specify the value (in seconds) for the frame pattern detection
timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds>
Default Values
By default, the bonding txfa-timer value is set to 10 seconds.
Functional Notes
Specifies the length of time the endpoint attempts to detect the bonding frame pattern when a call is
connected before deciding the bonding call has failed. When operating with other manufacturers' bonding
equipment, it may be necessary to change this time so that it matches TXADD01.
Usage Examples
The following example defines a bonding txfa-timer value of 15 seconds:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#bonding txfa-timer 15
5991-2114
Specifies the number of seconds the endpoint allots for attempting to detect the
bonding frame pattern (when a call is connected) before considering the bonding
negotiation a failure.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
579