HP ProCurve 7102dl Reference Manual page 127

SROS Command Line Interface Reference Guide
debug ip tcp md5
Use the debug ip tcp md5 command to activate debug messages that detail the results of each incoming
TCP packet's MD5 authentication with an internal route in the SROS. Debug messages are displayed
(real-time) to the terminal (or Telnet) screen. Use the no form of this command to disable debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the SROS are disabled.
Functional Notes
Debug messages will only be generated for TCP ports that have MD5 authentication enabled.
Usage Examples
The following example activates the display of these debug messages:
ProCurve#debug ip tcp md5
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
125