HP ProCurve 7102dl Reference Manual page 372

SROS Command Line Interface Reference Guide
interface loopback <label>
Use the interface loopback command to create a virtual interface that can be assigned layer 3 and higher
properties and is always up unless the router is shut down. Use the no form of this command to delete a
configured loopback interface.
Syntax Description
<label>
Default Values
By default, there are no configured loopback interfaces.
Usage Examples
The following example creates a loopback virtual interface (labeled 1) and enters the Loopback Interface
Configuration mode:
ProCurve(config)#interface loopback 1
ProCurve(config-loop 1)#
5991-2114
Specifies the numerical virtual loopback interface identifying label (valid range:
1 to 1024)
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
370