HP ProCurve 7102dl Reference Manual page 224

SROS Command Line Interface Reference Guide
show ip ospf interface <interface>
Use the show ip ospf interface command to display OSPF information for a specific interface.
Syntax Description
<interface>
Default Values
No default value necessary for this command.
Usage Examples
The following example shows OSPF information for the ppp 1 interface.
ProCurve>enable
ProCurve#show ip ospf interface ppp 1
5991-2114
Optional. Specifies an interface in the format <interface type [slot/port |
slot/port.sub-interface id | interface id | interface id.sub-interface id | ap | ap/radio |
ap/radio.vap]>. For example, for a T1 interface use t1 0/1; for an Ethernet
sub-interface, use eth 0/1.1; for a PPP interface, use ppp 1; and for an ATM
sub-interface use atm 1.1. Type show ip ospf interface ? for a complete list of
applicable interfaces.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
222