Frame Relay Interface Config Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
F R
RAME ELAY
To activate the Frame Relay Interface Configuration mode, enter the interface frame-relay command at
the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface frame-relay 1
ProCurve(config-fr 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value>
encapsulation frame-relay ietf
fair-queue <threshold>
frame-relay commands
hold-queue <queue size> out
max-reserved-bandwidth <percent>
qos-policy out <mapname>
snmp trap on page 896
snmp trap link-status
5991-2114
I C
NTERFACE ONFIG
on page 1434
on page 878
on page 879
on page 880
begin on page 881
on page 893
on page 894
on page 895
on page 897
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Frame Relay Interface Config Command Set

C S
OMMAND ET
on page 1431
877