HP ProCurve 7102dl Reference Manual page 927

SROS Command Line Interface Reference Guide Frame Relay Sub-Interface Config Command Set
frame-relay be <excessive burst value>
Use the frame-relay be command to set the b (excessive burst) value for a Frame Relay sublink. The
e
value is in bits. Use the no form of this command to return to default.
Syntax Description
<excessive burst value> Specifies the excessive burst value (in bits) for the sublink.
Default Values
By default, the excessive burst value is set to 0 (no limit).
Functional Notes
The time interval is always one second, so this can also be considered bits per second. Shaping is
performed on a sliding one-second window to make maximum use of configured bandwidth. Note that
when both b c and b e are non-zero, shaping is performed on the virtual circuit. The circuit is limited to the
sum of b c and b e , and it is recommended that the sum always be greater than 8000.
Usage Examples
The following example configures the sublink fr 1.16 with an excessive burst value of 64000 bits:
ProCurve(config)#interface frame relay 1.16
ProCurve(config-fr 1.16)#frame-relay be 64000
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 925