HP ProCurve 7102dl Reference Manual page 227

SROS Command Line Interface Reference Guide
show ip pim-sparse [interfaces <interface> | neighbor | rp-map | rp-set |
state | traffic]
Use the show ip pim-sparse command to display Protocol Independent Multicast (PIM) configuration
information. Sparse mode or PIM-SM is a routing protocol used to establish and maintain the multicast
distribution tree. Routers can participate in the shared tree (RPT) rooted at the rendezvous point (RP)
router or the shortest-path tree (SPT) rooted at a multicast source. PIM-SM also establishes both shared
trees and shortest-path trees.
Syntax Description
interface <interface>
neighbor
rp-map
rp-set
state
traffic
Default Values
No default necessary for this command.
Usage Examples
The following example shows sample output from the show ip pim-sparse command:
ProCurve>enable
ProCurve#show ip pim-sparse
Global PIM Sparse Mode Settings
Join/Prune interval: 60, SPT threshold: 1
5991-2114
Displays PIM-SM configuration and status information for a specific interface.
Type show ip pim-sparse interface ? to display a list of applicable interfaces.
Displays neighbor adjacency information.
Displays active group-to-RP mappings.
Displays list of statically configured RP candidates. The group address is
224.0.0.0/4 when no access group was applied to the rp-address command
rp-address <ip address> access-group <access-list-name>
(refer to
1377). Otherwise it is the name of the access group.
Displays multicast route PIM state information.
Displays active PIM-SM control traffic statistics.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
on page
225