Event-History Priority [Error | Fatal | Info | Notice | Warning] - HP ProCurve 7102dl Reference Manual

Secure router sros command line interface

Hide thumbs Also See for ProCurve 7102dl:

Table of Contents

SROS Command Line Interface Reference Guide

Global Configuration Mode Command Set

event-history priority [error | fatal | info | notice | warning]

Use the event-history priority command to set the threshold for events stored in the event history. All

events with the specified priority or higher will be kept for viewing in the local event log. The event log

may be displayed using the show event-history command. Use the no form of this command to keep

specified priorities from being logged.

Syntax Description

Sets the minimum priority threshold for logging messages to the event history. The following priorities are

available (ranking from lowest to highest):

When selected, events with error and fatal priorities are logged.

When selected, only events with a fatal priority are logged.

When selected, all events are logged.

When selected, events with notice, warning, error, and fatal priorities are logged.

When selected, events with warning, error, and fatal priorities are logged.

Default Values

By default, no event messages are logged to the event history.

Functional Notes

The event history provides useful information regarding the status of the system and individual port states.

Use the event history as a troubleshooting tool when identifying system issues. The following is a sample

event history log.

ProCurve#show event-history

Using 526 bytes

2002.07.12 15:34:01 T1.t1 1/1 Yellow

2002.07.12 15:34:01 INTERFACE_STATUS.t1 1/1 changed state to down.

2002.07.12 15:34:02 T1.t1 1/1 No Alarms

2002.07.12 15:34:02 INTERFACE_STATUS.t1 1/1 changed state to up.

2002.07.12 15:34:03 INTERFACE_STATUS.eth 0/1 changed state to up.

2002.07.12 15:34:10 OPERATING_SYSTEM Warm Start

2002.07.12 15:34:12 PPP.NEGOTIATION LCP up

2002.07.12 15:34:12 PPP.NEGOTIATION IPCP up

Table of Contents