Isdn [Ldn 1 | Ldn 2] <Ldn - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
isdn [ldn 1 | ldn 2] <ldn>
Use the isdn ldn command to specify the Local Directory Numbers (LDNs) for the Basic Rate ISDN (BRI)
interface. This information should be supplied by your service provider. Use the no form of this command
to remove a configured LDN.
Note
The BRI module requires all incoming calls to be directed to the Local Directory Number
(LDN) associated with the SPID programmed using the isdn spid1 command. All calls to
the LDN associated with SPID 2 will be rejected (unless part of a bonding call).
Syntax Description
ldn 1
ldn 2
<ldn>
Default Values
By default, there are no configured LDNs.
Functional Notes
Inbound calls are not accepted on interfaces without programmed LDNs. LDNs can also be entered using
the isdn spid command. The isdn spid and isdn ldn commands overwrite the existing programmed LDN;
therefore the last LDN programming entered takes precedence.
Usage Examples
The following example defines an LDN of 555-1111:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#isdn ldn1 5551111
5991-2114
Specifies the LDN associated with the SPID entered as SPID 1.
Specifies the LDN associated with the SPID entered as SPID 2.
Specifies the LDN assigned to the circuit by the service provider. The LDN is the
number used by remote callers to dial into the ISDN circuit.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
583