HP ProCurve 7102dl Reference Manual page 146

SROS Command Line Interface Reference Guide
debug tacacs+ packets
Use the debug tacacs+ packets command to activate debug messages associated with terminal access
controller access control system (TACACS+) protocol. Debug messages are displayed (real-time) to the
terminal (or Telnet) screen. Use the no form of this command to disable the debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
events
packets
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example activates debug messages associated with the TACACS+ protocol:
ProCurve>enable
ProCurve#debug tacacs+ packets
5991-2114
Activates TACACS+ event debug messages.
Activates TACACS+ packet debug messages.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
144