HP ProCurve 7102dl Reference Manual page 178

SROS Command Line Interface Reference Guide
show crypto map
Use the show crypto map command to display information regarding crypto map settings. Variations of
this command include the following:
show crypto map
show crypto map <interface>
show crypto map <map name>
show crypto map <map name> <map number>
Syntax Description
<interface>
<map name>
<map number>
Default Values
No default value necessary for this command.
Usage Examples
The following is a sample from the show crypto map command:
ProCurve> enable
ProCurve#show crypto map testMap
Crypto Map "testMap" 10 ipsec-ike
Extended IP access list NewList
Peers:
172.27.45.57
Transform sets:
esp-des
Security-association lifetimes:
0 kilobytes
86400 seconds
No PFS group configured
Interfaces using crypto map testMap:
eth 0/1
5991-2114
Displays the crypto map settings for the specified interface. Type show
interfaces ? for a complete list of valid interfaces.
Specifies a specific crypto map name.
Specifies a specific crypto map number.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
176