SROS Command Line Interface Reference Guide
ip rip summary-address <network address> <network mask>
Use the ip rip summary-address command to manually summarize the routes Routing Information
Protocol (RIP) will advertise and send out a specified interface. Use the no form of this command to
disable this mode.
Syntax Description
<network address>
<network mask>
Default Values
By default, no manual summarization is applied by RIP.
Functional Notes
Unlike the automatic summarization on classful network boundaries, only specific network advertisements
are made by RIP using the ip rip summary-address command. This command is only effective if RIP
version 2 is configured.
Usage Examples
The following example enables manual summarization on the specified IP address:
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#ip rip summary-address 10.10.123.0 255.255.255.0
5991-2114
Specifies the IP address of the network to be summarized.
Specifies the network mask to be applied to the specific network to be
summarized.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
770