HP ProCurve 7102dl Reference Manual page 677

SROS Command Line Interface Reference Guide
speed [10 | 100 | auto]
Use the speed command to configure the speed of an Ethernet interface. Use the no form of this command
to return to the default value.
Syntax Description
10
100
auto
Note Some Ethernet equipment (though rare) is unable to negotiate duplex if speed is manually
determined. To avoid incompatibilities, manually set the duplex if the speed is manually set.
See speed [10 | 100 | auto] on page 675 for more information.
Default Values
By default, speed is set to auto.
Usage Examples
The following example configures the Ethernet port for 100 Mb operation:
ProCurve(config)#interface ethernet 0/1
ProCurve(config-eth 0/1)#speed 100
5991-2114
10 Mb Ethernet
100 Mb Ethernet
Automatically detects 10 or 100 Mb Ethernet and negotiates the duplex setting in
the following order: 100/full, 100/half, 10/full, 10/half.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Ethernet Interface Configuration Command Set
675