HP ProCurve 7102dl Reference Manual page 457

SROS Command Line Interface Reference Guide
ip urlfilter <name> http
Use the ip urlfilter http command to create a URL filter for Hypertext Transfer Protocol (HTTP) (TCP
port 80) traffic. Use the no form of this command to delete the specified HTTP URL filter.
Note
The URL filtering software runs on a server independent of the SROS product. For
additional information about the URL filtering technology, refer to the vendor's website.
Syntax Description
<name>
Default Values
By default, no URL filters are configured.
Functional Notes
The firewall must be enabled using the ip firewall command in order to use URL filters. The URL filter
must be applied to the appropriate interface by using the ip urlfilter <filtername> [in | out] command.
Refer to this command in the appropriate interface for more information.
Usage Examples
The following example creates the HTTP URL filter called MyFilter that can be applied to an interface for
content filtering:
ProCurve(config)#ip urlfilter MyFilter http
5991-2114
Specifies the URL filter name.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
455