Frame Relay Sub-Interface Config Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
F R
RAME ELAY
To activate the Frame Relay Interface Configuration mode, enter the interface frame-relay command
(and specify a sub-interface) at the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface frame-relay 1.16
ProCurve(config-fr 1.16)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
backup commands
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dynamic-dns on page 922
frame-relay bc <committed burst value>
frame-relay be <excessive burst value>
frame-relay fragment <threshold>
frame-relay interface-dlci <dlci>
ip commands begin on page 928
lldp receive on page 957
lldp send [management-address l port-description l system-capabilities l system-description l
system-name] on page 958
lldp send-and-receive
5991-2114
S -I
UB NTERFACE
on page 1434
on page 900
begin on page 901
on page 918
on page 919
on page 920
on page 924
on page 925
on page 926
on page 927
on page 959
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Frame Relay Sub-Interface Config Command Set

C C
ONFIG OMMAND
S
ET
on page 1431
898