HP ProCurve 7102dl Reference Manual page 266

SROS Command Line Interface Reference Guide
show route-map [<name>]
Use the show route-map command to display any route maps that have been configured in the router. It
displays any match and set clauses associated with the route map, as well as the number of incoming routes
that have matched each route map.
Syntax Description
<name>
Default Values
By default, this command displays all defined route maps.
Usage Examples
In the example below, all route maps in the router are displayed.
ProCurve>enable
ProCurve#show route-map
route-map RouteMap1, permit, sequence 10
Match clauses:
community (community-list filter): CommList1
Set clauses:
local-preference 250
BGP Filtering matches: 75 routes
route-map RouteMap1, permit, sequence 20
Match clauses:
community (community-list filter): CommList2
Set clauses:
local-preference 350
BGP Filtering matches: 87 routes
route-map RouteMap2, permit, sequence 10
Match clauses:
ip address (access-lists): 192.168.1.1
Set clauses:
metric 100
BGP Filtering matches: 10 routes
route-map RouteMap2, permit, sequence 20
Match clauses:
ip address (access-lists): 192.168.2.1
Set clauses:
metric 200
5991-2114
Optional. Displays only the route map matching the specified name.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
264