HP ProCurve 7102dl Reference Manual page 954

SROS Command Line Interface Reference Guide
ip rip send version [1 | 2]
Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets
transmitted on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Functional Notes
Use the ip rip send version to specify a RIP version that will override the version (in the Router RIP)
configuration.
The SROS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures a Frame Relay sub-interface to transmit only RIP version 2 packets:
ProCurve(config)#interface frame-relay 1.16
ProCurve(config-fr 1.16)#ip rip send version 2
5991-2114
Transmits only RIP version 1 packets on the interface.
Transmits only RIP version 2 packets on the interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Frame Relay Sub-Interface Config Command Set
952