HP ProCurve 7102dl Reference Manual page 215

SROS Command Line Interface Reference Guide
show ip igmp groups <group-address>
Use the show ip igmp groups command to display the multicast groups that have been registered by
directly connected receivers using IGMP. If no group address is specified, all groups are shown with this
command.
Syntax Description
<group-address>
Default Values
No default value necessary for this command.
Usage Examples
The following is sample output from this command:
ProCurve>enable
ProCurve#show ip igmp groups
IGMP Connected Group Membership
Group Address Interface
172.0.1.50 Loopback100
172.1.1.1 Ethernet0/1
172.1.1.1 Loopback100
5991-2114
Optional. Displays IP address of a multicast group.
Uptime
00:42:57
00:05:26
00:42:57
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Expires Last Reporter
00:02:50 172.23.23.1
00:02:51 1.1.1.2
00:02:51 172.23.23.1
Enable Mode Command Set
213