SROS Command Line Interface Reference Guide
show ip local policy
Use the show ip local policy command to display information about the route-map used for local
policy-based routing.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Usage Examples
The following is sample output from this command:
ProCurve>enable
ProCurve#show ip local policy
Local policy routing is enabled, using route-map equal
route-map equal, permit, sequence 10
Match clauses:
length 150 200
Set clauses:
ip next-hop 10.10.11.254
Policy routing matches: 0 packets, 0 bytes
route-map equal, permit, sequence 20
Match clauses:
ip address (access-lists): 101
Set clauses:
ip next-hop 10.10.11.14
Policy routing matches: 2 packets, 172 bytes
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
216