HP ProCurve 7102dl Reference Manual page 600

SROS Command Line Interface Reference Guide
signaling-mode [message-oriented | none | robbed-bit]
Use the signaling-mode command to configure the signaling type (robbed bit for voice or clear channel for
data) for the DS0s mapped to the DSX-1 port.
Syntax Description
message-oriented
none
robbed-bit
Default Values
By default, the signaling mode is set to robbed-bit.
Usage Examples
The following example configures the DSX-1 port for PRI compatibility:
ProCurve(config)#interface t1 1/2
ProCurve(config-t1 1/2)#signaling-mode none
5991-2114
Specifies clear channel signaling on Channel 24 only. Use this signaling type with
QSIG installations.
Specifies clear channel signaling on all 24 DS0s. Use this signaling type with
data-only or PRI DSX-1 installations.
Specifies robbed bit signaling on all DS0s. Use this signaling type for voice-only
DSX-1 applications.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
DSX-1 Interface Configuration Command Set
598