HP ProCurve 7102dl Reference Manual page 988

SROS Command Line Interface Reference Guide
backup redial-delay <seconds>
Use the backup redial-delay command to configure the delay after an unsuccessful call until the call will
be re-tried. For more detailed information on backup functionality, refer to the Functional Notes section of
the command backup call-mode <role> on page 976.
Syntax Description
<seconds>
Default Values
By default, backup redial-delay is set to 10 seconds.
Usage Examples
The following example configures a redial delay of 25 seconds on this endpoint:
ProCurve(config)#interface hdlc 1
ProCurve(config-hdlc 1)#backup redial-delay 25
5991-2114
Specifies the delay in seconds between attempting to re-dial a failed backup
attempt. Range: 10 to 3600.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
HDLC Command Set
986