SROS Command Line Interface Reference Guide
Enable Mode Command Set
Usage Examples
The following is sample output for the debug ip packet command:
ProCurve>enable
ProCurve#debug ip packet
IP: s= 192.168.8.101 (eth 0/1) d=192.168.7.2 (eth 0/2) g= 192.168.7.2, forward
IP: s= 192.168.7.2 (eth 0/2) d=192.168.8.101 (eth 0/1) g= 192.168.8.101, forward
IP: s= 192.168.8.101 (eth 0/1) d=192.168.7.2 (eth 0/2) g= 192.168.7.2, forward
IP: s= 192.168.7.2 (eth 0/2) d=192.168.8.101 (eth 0/1) g= 192.168.8.101, forward
Where:
s=192.168.8.101 (eth 0/1) indicates source address and interface of received packet.
d=192.168.7.2 (eth 0/2) indicates destination address and interface from which the packet is being sent.
g=192.168.7.2 indicates the address of the next hop gateway.
forward indicates the router is forwarding this packet.
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
114