SROS Command Line Interface Reference Guide
loopback network [line | payload]
Use the loopback network command to initiate a loopback on the interface toward the network. Use the
no form of this command to deactivate the loopback.
Syntax Description
line
payload
Default Values
No default necessary for this command.
Functional Notes
The following diagram depicts a line loopback.
Usage Examples
The following example initiates a line loopback of the E1 interface:
ProCurve(config)#interface e1 1/1
ProCurve(config-e1 1/1)#loopback network line
5991-2114
Initiates a metallic loopback of the physical E1 network interface.
Initiates a loopback of the E1 framer (CSU portion) of the E1 network interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
E1 Interface Configuration Command Set
606