HP ProCurve 7102dl Reference Manual page 868

SROS Command Line Interface Reference Guide
On the peer (hostname Peer):
Peer(config-demand 1)#ppp pap sent-username farend password same
The first line of the configuration sets the authentication mode as PAP. This means the peer is required to
authenticate itself to the local router via PAP. The second line is the username and password expected to
be sent from the peer. On the peer, the ppp pap sent-username command is used to specify the
appropriate matching username and password.
Configuring PAP Example 2: Both routers require the peer to authenticate itself.
On the local router (hostname Local):
Local(config-demand 1)#ppp authentication pap
Local(config-demand 1)#username farend password far
Local(config-demand 1)#ppp pap sent-username nearend password near
On the peer (hostname Peer):
Peer(config-demand 1)#ppp authentication pap
Peer(config-demand 1)#username nearend password near
Peer(config-demand 1)#ppp pap sent-username farend password far
Now both routers send the authentication request, verify that the username and password sent match what
is expected in the database, and send an authentication acknowledge.
Defining CHAP
The Challenge-Handshake Authentication Protocol (CHAP) is a three-way authentication protocol
composed of a challenge response and success or failure. The MD5 protocol is used to protect usernames
and passwords in the response.
First, the local router (requiring its peer to be authenticated) sends a "challenge" containing only its own
unencrypted username to the peer. The peer then looks up the username in the username database within
the PPP interface, and if found takes the corresponding password and its own hostname and sends a
"response" back to the local router. This data is encrypted. The local router verifies that the username and
password are in its own username database within the PPP interface, and if so sends a "success" back to
the peer.
Note
The PPP username and password database is separate and distinct from the global
username password database. For PAP and CHAP, use the database under the PPP
interface configuration.
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Demand Interface Configuration Command Set
866