HP ProCurve 7102dl Reference Manual page 454

SROS Command Line Interface Reference Guide
ip tacacs source-interface <interface>
Use the ip tacacs source-interface command to specify a source IP address for TACACS+ traffic
originated by the unit. Use the no form of this command to disable this feature.
Syntax Description
<interface>
Default Values
No default value is necessary for this command.
Functional Notes
This command allows you to override the sender field in the IP packet. If you have multiple interfaces in
your unit, changing the sender tells the receiver where to send replies. This functionality can also be used
to allow packets to get through firewalls that would normally block the flow.
Usage Examples
The following example configures the unit to use the loopback 1 interface as the source IP for TACACS+
traffic:
ProCurve(config)#ip tacacs source-interface loopback 1
5991-2114
Specifies the interface to be used as the source IP address for TACACS+
traffic. Type ip tacacs source-interface ? for a complete list of valid
interfaces.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
452