HP ProCurve 7102dl Reference Manual page 828

SROS Command Line Interface Reference Guide
connect-sequence attempts <value>
Use the connect-sequence attempts command to limit the number of times the connect sequence will
cycle when its entries are unable to establish a connection. When the maximum number of attempts is
exhausted, the interface will go into recovery mode. Refer to connect-sequence interface-recovery
[retry-interval <seconds> | max-retries <value>] on page 827 for more information. Use the no form of
this command to restore the default values.
Syntax Description
<value>
Default Values
By default the connect-sequence attempts are unlimited.
Usage Examples
The following example instructs demand interface 1 to attempt its connection sequence 500 times:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#connect-sequence attempts 500
5991-2114
Specifies the number of times the connect sequence will cycle through its entries
if it is unable to make a connection. Range is 0 to 65,535.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Demand Interface Configuration Command Set
826