HP ProCurve 7102dl Reference Manual page 851

SROS Command Line Interface Reference Guide Demand Interface Configuration Command Set
ip policy route-map <mapname>
Use the ip policy route-map command to assign a policy route map to this interface. Use the no form of
this command to remove the assignment. Removing a route map from the interface does not remove the
route map configuration parameters from the system.
Syntax Description
<mapname> Specifies the route map to associate with this interface.
Default Values
By default, policy-based routing is disabled for all interfaces.
Usage Examples
The following example associates the route map named MyMap with demand interface 1:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#ip policy route-map MyMap
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 849