HP ProCurve 7102dl Reference Manual page 489

SROS Command Line Interface Reference Guide
radius-server
Use the radius-server command to configure several global RADIUS parameters. Most of these global
defaults can be overridden on a per-server basis.
Variations of this command include the following:
radius-server challenge-noecho
radius-server deadtime <minutes>
radius-server enable-username <name>
radius-server key <key>
radius-server retry <attempts>
radius-server timeout <seconds>
Syntax Description
challenge-noecho
deadtime <minutes>
enable-username <name>
key <key>
retry <attempts>
timeout <seconds>
Default Values
challenge-noecho
deadtime
key
retry
timeout
enable-username
5991-2114
Turns off echoing of user challenge-entry. When echo is turned on, users
see the text of the challenge as they type responses. Enabling this option
hides the text as it is being entered.
Specifies how long a RADIUS server is considered dead once a timeout
occurs. The server will not be tried again until after the deadtime expires.
Specifies a username to be used for enable authentication.
Specifies the shared key to use with a RADIUS server.
Specifies how many attempts to make on a RADIUS server before
marking it dead.
Specifies how long to wait for a RADIUS server to respond to a request.
By default, echo is turned on.
1 minute
No default
3 attempts
5 seconds
$enab15$
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
487