HP ProCurve 7102dl Reference Manual page 960

SROS Command Line Interface Reference Guide
lldp send [management-address l port-description l
system-capabilities l system-description l system-name]
Use the lldp send command to configure this interface to transmit LLDP packets or to control the types of
information contained in the LLDP packets transmitted by this interface.
Syntax Description
management-address Enables transmission of management address information on this interface.
port-description
system-capabilities
system-description
system-name
Default Values
By default, all interfaces are configured to transmit and receive LLDP packets of all types.
Functional Notes
Individual LLDP information can be enabled or disabled using the various forms of the lldp send
command. For example, use the lldp send and-receive command to enable transmit and receive of all
LLDP information. Then use the no lldp send port-description command to prevent LLDP from
transmitting port description information.
Usage Examples
The following example configures the Frame Relay sub-interface to transmit LLDP packets containing all
enabled information types:
ProCurve(config)#interface frame-relay 1.16
ProCurve(config-fr 1.16)#lldp send
5991-2114
Enables transmission of port description information on this interface.
Enables transmission of this device's system capabilities on this interface.
Enables transmission of this device's system description on this interface.
Enables transmission of this device's system name on this interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Frame Relay Sub-Interface Config Command Set
958