SROS Command Line Interface Reference Guide
Global Configuration Mode Command Set
router pim-sparse
Use the router pim-sparse command to globally enable protocol-independent multicast (PIM) on the unit
and to enter the PIM Sparse Configuration mode. Refer to the section Router (PIM Sparse) Configuration
Command Set on page 1375 for more information on the subcommands for PIM Sparse Configuration
mode.
Syntax Description
No subcommands.
Default Values
No default values necessary for this command.
Functional Notes
Additional commands for PIM are found in the related interface configuration modes. See the
ip pim-sparse commands in the various interface configuration sections for more information.
Usage Examples
The following example uses the router pim-sparse command to enter the PIM Sparse Configuration
mode:
ProCurve(config)#router pim-sparse
ProCurve(config-pim-sparse)#
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
493