HP ProCurve 7102dl Reference Manual page 411

SROS Command Line Interface Reference Guide
ip firewall policy-log threshold <value>
Use the ip firewall policy-log threshold command to specify the number of connections required by an
access control policy before the SROS will generate a log message. Use the no form of this command to
return to the default threshold.
Note
The SROS security features must be enabled (using the ip firewall command) for the
stateful inspection firewall to be activated.
Syntax DescriptionSyntax Description
<value>
Default Values
By default, the ip firewall policy-log threshold is sest to 100.
Usage Examples
The following example specifies a threshold of 15 connections before generating a log message:
ProCurve(config)#ip firewall policy-log threshold 15
5991-2114
Specifies the number of access policy connections the SROS will identify before
generating a log message (valid range: 0 to 4,294,967,295).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
409