SROS Command Line Interface Reference Guide
connect-mode [answer | originate | either]
Use the connect-mode command to configure the interface to only answer calls, only originate calls, or to
both answer and originate calls. Use the no form of this command to restore the default values.
Syntax Description
answer
originate
either
Default Values
By default the connect mode is set to both answer and originate calls.
Usage Examples
The following example configures demand interface 1 to only answer calls:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#connect-mode answer
5991-2114
Specifies the interface may be used to answer calls but not originate calls.
Specifies the interface may be used to originate calls but not answer calls.
Specifies the interface may be used to answer and originate calls.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Demand Interface Configuration Command Set
823