HP ProCurve 7102dl Reference Manual page 201

SROS Command Line Interface Reference Guide
show ip as-path-list [<listname>]
Use the show ip as-path-list command to display any AS path lists that have been configured in the router,
along with any permit and deny clauses in each list.
Syntax Description
<listname>
Default Values
By default, this command displays all AS path lists.
Usage Examples
In the following example, all AS path lists defined in the router are displayed.
ProCurve>enable
ProCurve#show ip as-path-list
ip as-path-list AsPathList1:
permit 100
permit 200
permit 300
deny 6500
ip as-path-list AsPathList2:
permit 400
permit 500
In the following example, only the AS path list with the name AsPathList2 is displayed.
ProCurve>enable
ProCurve#show ip as-path-list AsPathList2
ip as-path-list AsPathList2:
permit 400
permit 500
5991-2114
Optional. Specifies that the command display only the list matching the specified
AS path listname. If not specified, all AS path lists are displayed.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
199