HP ProCurve 7102dl Reference Manual page 153

SROS Command Line Interface Reference Guide
erase
Use the erase command to erase the specified file. Variations of this command include:
erase SROS.biz
erase startup-config
erase cflash <filename>
erase flash <filename>
Syntax Description
SROS.BIZ
startup-config
cflash
flash
<filename>
Default Values
No default value necessary for this command.
Usage Examples
The following example erases the startup configuration file stored in flash memory:
ProCurve>enable
ProCurve#erase startup-config
If a new startup-configuration file is not specified before power-cycling the unit, the SROS will initialize
using a default configuration.
The following example erases the file myfile.biz stored in flash memory:
ProCurve>enable
ProCurve#erase flash myfile.biz
5991-2114
Erases the SROS.BIZ file stored in flash memory. The SROS.BIZ file is the
current software. If the autosynch feature is enabled (using the global
configuration autosynch-mode command), the SROS.BIZ file is removed from
both flash and compact flash.
Erases the startup configuration file stored in flash memory. If the autosynch
feature is enabled (using the autosynch command), the startup-config file is
removed from both flash and compact flash.
Specifies the location of the file to erase as the installed compact flash card.
Specifies the location of the file to erase as the system flash memory.
Specifies the name of the file to erase. The asterisk (*) can be used as a wildcard
to specify a pattern for erasing multiple files. When a wildcard is specified, only
files matching the listed pattern are erased.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
151