HP ProCurve 7102dl Reference Manual page 657

SROS Command Line Interface Reference Guide
ip rip send version [1 | 2]
Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets
transmitted on the interface.
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Functional Notes
Use the ip rip send version command to specify a RIP version that overrides the version (in the Router
RIP) configuration.
The SROS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the Ethernet interface to transmit only RIP version 2 packets:
ProCurve(config)#interface eth 0/1
ProCurve(config-eth 0/1)#ip rip send version 2
5991-2114
Transmits RIP version 1 packets received on the interface.
Transmits RIP version 2 packets received on the interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Ethernet Interface Configuration Command Set
655