HP ProCurve 7102dl Reference Manual page 229

SROS Command Line Interface Reference Guide
The following example shows sample output from the show ip pim-sparse rp-map command:
ProCurve>enable
ProCurve#show ip pim-sparse rp-map
Number of group-to-RP mappings: 5
Group address
---------------------------------------------------------
225.1.0.1
225.1.0.2
225.1.0.3
The following example shows sample output from the show ip pim-sparse rp-map set command:
ProCurve>enable
ProCurve#show ip pim rp-map set
Group address
--------------------------------------------------------------
224.0.0.0/4
MCAST_ACL_1
MCAST_ACL_2
MCAST_ACL_3
The following example shows sample output from the show ip pim-sparse state command:
ProCurve>enable
ProCurve#show ip pim-sparse state
PIM-SM State Table
Flags: S - Sparse, C - Connected, P - Pruned, J - Join SPT, T - SPT-bit Set,
F - Register, R - RP-bit Set
Timers: Uptime/Expires
(*, 225.1.0.1), 02:42:03/00:03:04, RP 192.168.0.254, Flags: SC
Forwarding Entry: Yes
Incoming interface: tunnel 2, RPF nbr 172.16.2.10
Upstream Join/Prune State: Joined
Register State: No Info
RegStop Timer (sec): stopped
Join/Prune Timer (sec): 57
Override Timer (sec): stopped
Multicast Border Router: 0.0.0.0
Packets Forwarded: 2
Outgoing interface list:
5991-2114
RP address
192.168.0.254
192.168.0.254
192.168.0.254
Static-RP-address
192.168.0.254
192.168.1.254
192.168.2.254
192.168.3.254
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
227