SROS Command Line Interface Reference Guide
ip firewall check rst-seq
Use the ip firewall check rst-seq command to enable TCP reset sequence number checking. Use the no
form of this command to disable this feature.
Note
The SROS security features must be enabled (using the ip firewall command) for the
stateful inspection firewall to be activated.
Syntax Description
No subcommands.
Default Values
All SROS security features are disabled by default until the ip firewall command is issued at the Global
Configuration prompt. In addition, TCP reset sequence number checking is disabled until the
ip firewall check rst-seq command is issued.
Usage Examples
The following example enables TCP reset sequence number checking:
ProCurve(config)#ip firewall check rst-seq
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
404