HP ProCurve 7102dl Reference Manual page 125

SROS Command Line Interface Reference Guide
debug ip routing
Use the debug ip routing command to activate debug messages associated with routing table events.
Debug messages are displayed (real-time) to the terminal (or Telnet) screen. Use the no form of this
command to disable the debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following sample activates ip routing debug messages:
ProCurve>enable
ProCurve#debug ip routing
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
123