HP ProCurve 7102dl Reference Manual page 678

SROS Command Line Interface Reference Guide
traffic-shape rate <rate> <burstrate>
Use the traffic-shape rate command to specify and enforce an output bandwidth for Ethernet and VLAN
interfaces.
Syntax Description
<rate>
<burstrate>
Default Values
By default, traffic-shaping rate is disabled.
Functional Notes
Traffic shaping can be used to limit an Ethernet segment to a particular rate or to specify use of QoS on
Ethernet or VLAN interfaces.
Usage Examples
The following example sets the outbound rate of eth 0/1 to 128 kbps and applies a QoS policy that all RTP
traffic is given priority over all other traffic:
ProCurve(config)#qos map voip 1
ProCurve(config-qos-map)#match ip rtp 10000 10500 all
ProCurve(config-qos-map)#priority unlimited
ProCurve(config-qos-map)#interface eth 0/1
ProCurve(config-eth 0/1)#traffic-shape rate 128000
ProCurve(config-eth 0/1)#qos-policy out voip
5991-2114
Specifies the rate (in bits per second) at which the interface should be shaped.
Optional. Specifies the allowed burst in bytes. By default, this is specified to the rate
divided by 5 to represent the number of bytes that would flow within 200 ms.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Ethernet Interface Configuration Command Set
676