HP ProCurve 7102dl Reference Manual page 291

SROS Command Line Interface Reference Guide
show users [realtime]
Use the show users command to display the name (if any) and state of users authenticated by the system.
Displayed information includes:
• Connection location (for remote connections this includes TCP information)
• Username of authenticated user
• Current state of the login (in process or logged in)
• Current enabled state
• Time the user has been idle on the connection
Syntax Description
realtime
Default Values
No default value necessary for this command.
Functional Notes
Use the realtime argument for this command to display full-screen output in real-time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit reatime
mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the information
will truncate at the bottom of the screen. In order to maximize the amount of data displayed, increase the
terminal length (using the #terminal length command).
Usage Examples
The following is a sample of show users output:
ProCurve>enable
ProCurve#show users
- CONSOLE 0 'user' logged in and enabled
Idle for 00:00:00
- TELNET 0 (172.22.12.60:3998) 'password-only' logged in (not enabled)
Idle for 00:00:14
- FTP (172.22.12.60:3999) 'user' logged in (not enabled)
Idle for 00:00:03
5991-2114
Displays full-screen output in real-time. See the Functional Notes below for more
information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
289