HP ProCurve 7102dl Reference Manual page 530

SROS Command Line Interface Reference Guide
spanning-tree priority <value>
Use the spanning-tree priority command to set the priority for spanning-tree interfaces. The lower the
priority value, the higher the likelihood the configured spanning-tree interface will be the root for the
bridge group. To return to the default bridge priority value, use the no version of this command.
Syntax Description
<value>
Default Values
<value>
Usage Examples
The following example sets spanning-tree priority to the maximum level:
ProCurve(config)#spanning-tree priority 0
5991-2114
Priority value for the bridge interface. Configuring this value to a low number
increases the interface's chance of being the root. Therefore, the maximum
priority level would be 0. Range: 0 to 65,535.
32768
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
528