Show Ip Ospf - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide

show ip ospf

Use the show ip ospf command to display general information regarding OSPF processes.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Usage Examples
The following is a sample output from the show ip ospf command:
ProCurve>enable
ProCurve#show ip ospf
Summary of OSPF Process with ID: 192.168.72.101
Supports only single Type Of Service routes (TOS 0)
SPF delay timer: 5 seconds, Hold time between SPFs: 10 seconds
LSA interval: 240 seconds
Number of external LSAs: 0, Checksum Sum: 0x0
Number of areas: 0, normal: 0, stub: 0, NSSA: 0
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
219