HP ProCurve 7102dl Reference Manual page 42

SROS Command Line Interface Reference Guide
clear ip igmp group [<group-address> | <interface>]
Use the clear ip igmp group command to clear entries from the Internet Group Management Protocol
(IGMP) tables. If no address or interface is specified, all non-static IGMP groups are cleared with this
command.
Syntax Description
<group-address>
<interface>
Default Values
No default value necessary for this command.
Usage Examples
The following example shows output for the show igmp groups command before and after a
clear ip igmp group command is issued. This example clears the IGMP entry that was registered
dynamically by a host. Interfaces that are statically joined are not cleared:
ProCurve>enable
ProCurve#show ip igmp groups
Group Address
172.16.1.50
172.21.1.1
172.31.1.1
ProCurve#clear ip igmp group
ProCurve#show ip igmp groups
Group Address
This version of the command clears all dynamic groups that have the specified output interface
(Ethernet 0/1):
ProCurve#clear ip igmp group ethernet 0/1
This version of the command clears the specified group on all interfaces where it is dynamically registered:
ProCurve#clear ip igmp group 172.21.1.1
5991-2114
Optional. Specifies the multicast IP address of the multicast group.
Optional. Designates the clearing of parameters for a specific interface (in the format
type slot/port). For example: eth 0/1.
Interface
Loopback100
Ethernet0/1
Loopback100
Interface
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Uptime Expires
01:22:59 00:02:46
00:00:14 00:02:45
01:22:59 00:02:46
Uptime Expires
Enable Mode Command Set
Last Reporter
172.23.23.1
1.1.1.2
172.23.23.1
Last Reporter
40