SROS Command Line Interface Reference Guide
The following example shows sample output from the show ip pim-sparse interfaces command:
ProCurve>enable
ProCurve#show ip pim-sparse interface
eth 0/1 is UP
PIM Sparse
DR: itself
Local Address: 192.168.1.254
Hello interval (sec): 30, Neighbor timeout (sec): 105
Propagation delay (ms): 500, Override interval (ms): 2500
tunnel 1 is UP
PIM Sparse
DR: 172.16.1.10
Local Address: 172.16.1.9
Hello interval (sec): 30, Neighbor timeout (sec): 105
Propagation delay (ms): 500, Override interval (ms): 2500
tunnel 2 is UP
PIM Sparse
DR: 172.16.2.10
Local Address: 172.16.2.9
Hello interval (sec): 30, Neighbor timeout (sec): 105
Propagation delay (ms): 500, Override interval (ms): 2500
The following example shows sample output from the show ip pim-sparse neighbor command:
ProCurve>enable
ProCurve#show ip pim-sparse neighbor
Port
Neighbor
------------------------------------------------------------------------------------------------------
tunnel 1
172.16.1.10
tunnel 2
172.16.2.10
5991-2114
Holdtime(sec) Age(sec)
105
19
105
23
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
Uptime(sec)
241908
241913
226