HP ProCurve 7102dl Reference Manual page 984

SROS Command Line Interface Reference Guide
backup maximum-retry <attempts>
Use the backup maximum-retry command to select the number of calls the router will make when
attempting to backup a link. Use the no form of this command to return to the default state. For more
detailed information on backup functionality, refer to the Functional Notes section of the command
backup call-mode <role> on page 976.
Syntax Description
<attempts>
Default Values
By default, backup maximum-retry is set to 0 attempts.
Usage Examples
The following example configures the SROS to retry a dial-backup call four times before considering
backup operation not available:
ProCurve(config)#interface hdlc 1
ProCurve(config-hdlc 1)#backup maximum-retry 4
5991-2114
Selects the number of call retries that will be made after a link failure (valid range
is 0 to 15). Setting this value to 0 will allow unlimited retries during the time the
network is failed.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
HDLC Command Set
982